ZTE Z288L User Manual
Confidential and Proprietary Information of ZTE CORPORATION 5
Please refer to the section
Settings - Device Settings – Reset
Reset your device by pressing and holding the
Reset
button.
1.
Remove battery cover
2.
Find a hole with a mark
Reset
on right side of the device bottom surface.
3.
Press and hold the
Reset
button hidden in the hole with a needle for 3 seconds or longer.
4.
Factory reset will take effect and then the device will restart.
Using the WPS (Optional)
If your client device supports WPS, you don’t have to input the password manually after WPS
has been available. Please do the following steps:
1. Log into the web UI by visiting
Please select
Device
Info
on the LCD screen or check the label on your device to get the default password
.
2. Select
Settings
>
Wi-Fi Settings
>
Basic Settings
to enable the
Broadcast Network Name
(SSID)
and to set the
Security Mode
.
NOTE
: If the current security mode is OPEN and encryption type is WEP, the WPS function is
useless.
3. Set a Wi-Fi password in WPA2 (AES)-PSK mode and WPA-PSK/WPA2-PSK mode
and then
click
Apply
to confirm the settings.
4.
Select
on your device’s LCD screen to start Wi-Fi Protected Setup authentication process.
5.
Enable the WPS function on your client to respond this authentication process.
6.
Follow the system prompts on your client to finish the connection.
NOTE
:
For the detailed operations about the client, please refer to the client’s instruction.
Internet Access
Connection Scenario
The following picture is the application example. All of the client devices can surf on the Internet at the
same time.
