Zte ZMAX 2, User Manual

For Your Safety

67

For Your Safety

66

FCC Regulations

This mobile phone complies with part 15 of the FCC Rules. 

Operation is subject to the following two conditions: (1) This 

device may not cause harmful interference, and (2) this device 

must accept any interference received, including interference 

that may cause undesired operation. 
This mobile phone has been tested and found to comply 

with the limits for a Class B digital device, pursuant to Part 

15 of the FCC Rules. These limits are designed to provide 

reasonable protection against harmful interference in a 

residential installation. This equipment generates, uses and 

can radiate radio frequency energy and, if not installed and 

used in accordance with the instructions, may cause harmful 

interference to radio communications. However, there is 

no guarantee that interference will not occur in a particular 

installation. If this equipment does cause harmful interference 

to radio or television reception, which can be determined by 

turning the equipment off and on, the user is encouraged to 

try to correct the interference by one or more of the following 

measures: 
• Reorient or relocate the receiving antenna. 
• Increase the separation between the equipment and receiver. 
• 

Connect the equipment into an outlet on a circuit different 

from that to which the receiver is connected. 

• Consult the dealer or an experienced radio/TV technician  

for help. 

Caution:

 Changes or modifications not expressly approved 

by the party responsible for compliance could void the user‘s 

authority to operate the equipment. The antenna(s) used 

for the transmitter must not be co-located or operating in 

conjunction with any other antenna or transmitter.  

RF Exposure Information (SAR)

This phone is designed and manufactured not to exceed the 

emission limits for exposure to radio frequency (RF) energy set by 

the Federal Communications Commission of the United States. 
During SAR testing, this device was set to transmit at its highest 

certified power level in all tested frequency bands, and placed 

in positions that simulate RF exposure in usage against the head 

with no separation, and near the body with the separation of 0.4 

inches (10 mm). Although the SAR is determined at the highest 

certified power level, the actual SAR level of the device while 

operating can be well below the maximum value. This is because 

the phone is designed to operate at multiple power levels so as 

to use only the power required to reach the network. In general, 

the closer you are to a wireless base station antenna, the lower 

the power output. 
The exposure standard for wireless devices employing a unit of 

measurement is known as the Specific Absorption Rate, or SAR. 

The SAR limit set by the FCC is 1.6 W/kg

.