ZXC10-BTS (V5.4) Installation Manual
10-12
Fig. 10.4-3 Adjusting the Pitch Angle of the Antenna
10.4.4 Installing and Adjusting the Omni Antenna
Take the following steps to install the omni antenna:
1. Put the jacket at the antenna lower part close to the support backbone. The top of
the jacket should be flush with or slightly higher than the support top;
2. Fix the jacket at the antenna lower part and the support backbone at two points
with antenna fixing clips. They should be fixed tight enough to bear weight and
withstand wind, and should not be too loose or too tight lest the antenna jacket
be damaged.
3. Check the antenna verticality. The omni antenna must be vertical. Make sure the
antenna is vertical, and then fix it to the antenna embracing pole.
4. Stick the support installed with the antenna out of the tower platform, and adjust
the support to make the antenna vertical.
10.4.5 Connecting and Sealing the Jumper and the Antenna
Note:
The antenna and the jumper can be connected and waterproof treatment can be
conducted on the joint before the antenna is fixed on the embracing pole. This
can reduce the time working at heights and improve the joint connection and
waterproof quality. The installation steps are as follows:
1. Align the connector of the antenna jumper to the antenna interface and screw it
tightly.
