Chapter
13
Installing the Integrated
Micro-BTS
13-9
See below for the meaning of each connector:
POWER——Power input of the micro-BTS;
FIBER
-
1\
-
2——Extension fiber interface of the RF remote station;
FIBER
-
3\
-
4——Input/output of the built-in SDH fiber interface of the micro-BTS;
MONITOR——Communication interface of the external UPS of the micro-BTS
;
FAN——Fan interface for external heat dissipation of the high-power (over 20W)
micro-BTS;
RFE
-
ANT0——Diversity reception antenna interface of the micro-BTS;
RFE
-
ANT1——Main reception / transmission antenna interface of the micro-BTS;
GPS
-
ANT——GPS antenna interface;
SDH
-
POWER——Built-in SDH power supply interface of the micro-BTS;
T1——Four 2M signal interfaces;
EXTEND——RF extension interface of the multi-carrier micro-BTS.
13.2.2.2 Description of the Fiber Installation
Here the interfaces related with the built-in SDH are FIBER-3 and FIBER-4. FIBER-3
is the optical transmission input interface and FIBER-4 is the fiber transmission output
interface used for networking with the adjacent BTS.
Fig. 13.2-3 shows the position for installing the water-proof fiber at the bottom of the
micro-BTS cabinet and that for connecting and laying out the water-proof fiber inside
the cabinet.
The water-proof connector of the fiber is connected with the cabinet body in the similar
way to the fiber connection when the micro-BTS connects with the RF remote station.
The fiber is laid out in a naturally way after it goes into the cabinet and is connected
with the optical module on the SDH.
