Chapter
13
Installing the Integrated
Micro-BTS
13-11
DANGER OF HIGH VOLTAGE
Shutter for
air discharge
a
CLOSE
Key
OPEN
Front side of
enclosure
Rear side of
enclosure
Shutter for air
admittance
Fig. 13.3-1 Appearance of the ZXUPS L010 Series
Fig. 13.3-2 shows the inner structure of the ZXUPS L010 series.
外箱底部安装孔
外箱底部出水孔
外箱底部接地孔
外箱底部出线孔
外箱门
外箱底部导槽
外箱背部安装孔
Door panel
Rear-side
installation hole
Water outlet at
the bottom
Grounding hole
at the bottom
Leading-out hole
at the bottom
Installation hole
at the bottom
Bottom slide
Fig. 13.3-2 Inner Structure of the ZXUPS L010 Series
13.3.2 Precautions for UPS Installation
The following rules should be followed if the micro-BTS (800M or 1.9G) is to be
configured with an additional UPS:
1.
The UPS must be kept within two meters away from the micro-BTS. Because
current micro-BTS uses the BDM for monitoring the UPS and the RS-232
specification for communication, the communication distance is limited to 10
meters generally. To ensure correct communication, no more than two meters
should better be kept between two cabinets. As the UPS is relatively close to
the micro-BTS, lightning-protection may be ignored for between them.
