ZXCBTS (V5.4) CDMA Micro Base Transceiver Station & Remote Station Installation Manual
4-6
4.2.2 Installing Cabinet on Wall
1. Disassemble the support from the cabinet.
2. Mark four points on the wall based on the four holes on the support, and then
drill four holes with a percussive drill (using M12 drill bit). Secure the support
onto the wall with four M10 expansion bolts. See Fig. 4.2-5.
3. Hold the cabinet to hang it onto the support, and then push it into the shelf.
4. Align the bolt holes on the support with those on the cabinet, and then screw
down four M8 hexagon bolts.
5. Install the sunshade cover if the equipment is to be installed outdoors.
See Fig. 4.2-6 for the schematic diagram of installing cabinet on wall.
Wall
Support
Expansion bolt
Hexagon nut
Washer
Fig. 4.2-5 Schematic Diagram of Installing the Support onto the Wall
