ZXR10 8900 Series User Manual (Basic Configuration Volume)
Cluster Management
Configuration Example
This example describes how to connect two devices to implement
cluster management, as shown in
Figure 34
.
F
IGURE
34 C
LUSTER
M
ANAGEMENT
C
ONFIGURATION
E
XAMPLE
Configuration steps are as follows:
1. Ensure that two ports are in a VLAN (configured as vlan1 and
ensure that vlan1 does not configure Layer 3 address).
2. Execute
show zdp neighbor
on DUT A and ensure zdp neigh-
bor is already set up.
3. Execute
ztp start
on DUT A to conduct topology collection, and
then execute
show ztp device-list
to view DUT A and DUT B.
4. Configure DUT A as command switch with
group switch-type
command.
View command switch with
show group
com-
mand.
5. Configure DUT B as the member switch with
group member
device 1
command and then view Member 1 in the up state
with the
show group member
command.
6. Log in to Member 1 with the
rlogin member 1
command in
the privilege mode, and log in from Member 1 to the command
switch with the
rlogin commander
command.
Cluster Management
Maintenance and Diagnosis
To configure cluster management maintenance and diagnosis, per-
form the following steps.
Step Command
Function
1
ZXR10#
show zdp
This displays ZDP
configuration information
2
ZXR10#
show ztp
This displays ZTP
configuration information
3
ZXR10#
show group
This displays cluster
configuration information
4
ZXR10#
show zdp neighbour
[{
interface
<
interface
>}|{
mac
<
mac id
>}]
This displays ZDP neighbor
126
Confidential and Proprietary Information of ZTE CORPORATION
