Chapter 5 RIPng Configuration
5.2 Configuring RIPng
This procedure describes how to configure the attributes and functions of RIPng routes,
including protocol parameters, summarized routes, and redistribution of protocol routes.
Steps
1.
Enter RIPng configuration mode.
Command
Function
ZXR10(config)#
ipv6 router rip
Enters RIPng configuration
mode.
2.
Configure optional parameters of the RIPng protocol.
Command
Function
ZXR10(config-ripng)#
timers basic
<
update
><
timeout
><
gar
bage
>
Configures the timers of RIPng.
ZXR10(config-ripng)#
default-metric
<
metric
>
Sets the default metric of routes.
ZXR10(config-ripng)#
port
<
1-65535
>
Specifies the port for listening to
multicast packets, default: 521.
ZXR10(config-ripng)#
offset-list
<
access-list-number
>{
in
|
out
}<
offset
>
Configures the offset list of
the RIPng, offset metric value,
range: 0 to 16.
<
update
>: specifies the periodic packet sending interval (in seconds), range: 5 to
65535, default: 30.
<
timeout
>: specifies the time (in seconds) for the route to become invalid, range: 5 to
65535, default: 180.
<
garbage
>: specifies the time period (in seconds) from the time when the route
becomes invalid to the time when the route is deleted, range: 5 to 65535, default:
120.
in
|
out
: specifies the route as a receiving/transmitting route.
3.
Configures the summarized RIPng routes and the redistribution of protocol routes.
Command
Function
ZXR10(config-ripng)#
summary-prefix X:X::X:X/
<
0~128
>
Configures the summarized
routes of the RIPng.
ZXR10(config-ripng)#
redistribute
<
protocol
>[
metric
<
metric-value
>][
route-map
<
map-tag
>]
Configures the redistribution of
protocol routes.
<
protocol
>: specifies the name of the protocol whose routes are redistributed.
<
metric-value
>: specifies the metric for the redistributed routes, range: 1 to 16.
5-3
SJ-20140504150128-018|2014-05-10 (R1.0)
ZTE Proprietary and Confidential
