During the conference, press HOLD button and the
conference will be put on hold
- To resume the conference, press the ReConf
softkey
- To split the conference and resume the call
with each party, press the corresponding
line key
3.
End Conference:
If the users decide not to conference after establishing the
second call, press EndCall softkey instead of ConfCall
softkey/CONF button. It will end the second call and the
screen will show the first call is on hold.
During the conference, press EndCall softkey or hang up to
end the conference
NOTE:
•
The party that starts the conference call has to remain in the conference
for its entire duration, you can put the party on mute but it must
remain in the conversation. Also, this is not applicable when the
feature “Transfer on call hangup” is turned on.
•
When using Easy Conference mode, press SEND button to establish
the second call after entering the number instead of using “#”.
Voice Messages (Message Waiting Indicator)
A blinking red MWI (Message Waiting Indicator) on the top right corner of the
ZXV10 P802L indicates a message is waiting. Dial into the voicemail box to
retrieve the message. An IVR will prompt the user through the process of
message retrieval.
Shared Call Appearance (SCA)
The ZXV10 P802L phone supports shared call appearance by Broadsoft
standard. This feature allows members of the SCA group to shared SIP lines
and provides status monitoring (idle, active, progressing, hold) of the shared
line. When there is an incoming call designated for the SCA group, all of the
