Parameter Name
Description
Enable NAT
Enable/disable Network Address Translation (NAT). This
function can be configured in route mode only. It cannot
be configured in bridge mode.
Enable VLAN
Enable/disable VLAN configuration. VLAN ID and 802.1p
are used to define to which VLAN the device belongs
as well as the priority.
VLAN ID
VLAN ID of data packets at WAN interface. The value
ranges from 1 to 4094.
802.1p
Deals with priority, suitable for multiple WAN connections
only. The value ranges from 0 to 7. The default value is
0, which indicates no priority set. The greater the value
is, the higher the priority is.
VPI/VCI
VPI/VCI (Virtual Path/Channel Identifier) identifies virtual
path and virtual channel of a link.
In the case of first-time configuration, select
Create
, and
then configure the VPI/VCI values. Otherwise, select a
previously used VPI/VCI values from the drop-down list.
New VPI/VCI
Configures VPI/VCI values, which range from 0 to 255
and from 0 to 65535 respectively. Both of which are
provided by the ISP.
Encapsulation Type
The protocol encryption type, which supports LLC and
VCMUX.
Service Type
Configuration of ATM QoS which imposes restrictions on
uplink traffic. Four types are available: CBR, RT-VBR,
nRT-VBR and UBR.
Username/Password
Username and password for WAN connection
authentication. Both of which are provided by the ISP.
Authentication Type
Authentication protocol type. Options: Auto, PAP and
CHAP. The value is Auto by default.
Connection Trigger
Connection triggering mode. Options: Always On, On
Demand, and manual. The mode is Always on by default.
Idle Timeout
The default value is 1200 seconds. It can be set when
the
Connection Trigger
is set to
On Demand
only.
3.
Click
Create
to create connection.
9
