ZTechnik
PO Box Maywood, IL 60153-0158 USA
708-343-0400 / Fax: 708-343-0625 / www.ZTechnik.com / e mail: info@ZTechnik.com
©2011 National Cycle, Inc.
Page 3 of 5
10-118585-000 12/11
INSTALLATION
Remove and install the brackets to motorcycle
one side at a time.
1. MOUNT POINT-A
Remove the Left side screw only, from the head light
bracket located on the underside of the upper triple
tree clamp.
(T40 Torx Wrench) Figure 6.
Retain the OEM compression spacer. It will be
re-used.
Screw will not be re-used
2. MOUNT POINT- B
Remove the Left side screw and compression
spacer from the headlight bracket located on the
outside of the upper triple tree clamp.
Screw and
Compression Spacer will not be reused.
(T40 Torx Wrench) Figure 7.
3. INSTALL BRACKET
MOUNT POINT- A
Secure mount point A using original OEM
Compression spacer and a 45mm Screw (7).
(6mm Allen Wrench) Figure 8b
MOUNT POINT-B
Secure mount point B using supplied
Standoff (8) and a 45mm Screw (7)
(6mm Allen Wrench) Figure 8a and 8c
4.
Tighten all fasteners securely.
(6mm Allen Wrench)
5.
Follow the same procedure for the Right side of
motorcycle.
Figure 6
Figure 7
Figure 8b
Figure 8a
Figure 8c
B
A
Remove
Compression
Spacer
8
7
A
OEM
