12
Using a higher value for this setting will provide a wider Deadband.
2%,3%, 4% (Default) , 5%,6% ,10%
LED Program card
1. The ZTW Program card with LED display is easy to use and convenient to carry. All of the
programmable functions are shown on the program card.
2. Turn on the ESC. Remove the Signal wire and plug it into the top-socket on the Program
card , wait for 2 seconds until the LED is ON.
The first programmable function will be shown, if an error occurs, please reconnect them.
3. If ESC is not connected with the batteries, the Program card should be connected with other
power supply, the range of power supply is within 5.0-6.3V.
4. Press the button “Menu” on the Program card and circularly select each programmable
function. At that time the number of the programmable function will be displayed on the left of
the LED, the current value will be displayed on the right side. Then press the button Value to
change the value and press the button OK to confirm. At the same time the Red indicating LEDs
of both program card and the ESC blink. Turn off the ESC, the modified settings will be saved in
the ESC's memory.
5. Press the button Reset to restore the default settings.
