11
Seite
Seite
Page
Enter
010- CERAMAY
450C
Edit “ 140 CRISTALLISATION “
Program type
Special
-Start temp
450C
-Pre dry
Yes
-Pre dry time
2:00
-Closing time
4:00
-Soak temp
450C
-Soak time
0:30
-Heat rate 1
50C
-Final temp 1
900C
-Hold time 1
1:00
-Heat rate 2
45C
-Final temp 2
920C
-Hold time 2
0:25
-Open temp
920C
-Opening time
1:00
-Vacuum
Yes
-Release vacuum Heat up
-Vacuum End
820C
Esc
Start temperature
Temperature in the
firing chamber at which the program starts.
Pre-dry
Selecting “YES” activates the special pre-
drying program.
Pre-dry time
Enter a time. In this section, the lift
identifies a predefined position for the entire
time, depending on the heat radiated by the
firing chamber. The object can thus be pre-dried
at a constant temperature.
Closing time
Time in which the lift moves in 10
increments into the firing chamber.
Soak temperature
At this temperature, the object
remains in the closed firing chamber in order to
achieve an even temperature distribution.
Soak time
States the retention period of the object
in the firing chamber before evacuation and the
temperature increase.
Heat rate 1
Temperature increase per minute in
order to reach the final temperature 1.
Final temperature 1
Temperature 1 at which the
ceramic is sintered.
Hold time 1
Period for which the ceramic is main-
tained at the final temperature 1.
Heat rate 2
Temperature increase per minute in
order to reach the final temperature 2.
Final temperature 2
Temperature 2 at which the
ceramic is sintered.
Hold time 2
Period for which the ceramic is main-
tained at the final temperature 2.
Open temperature
Temperature at which the devi-
ce opens the firing chamber.
Opening time
Decent time of the lift from the
chamber to the fully open position.
Vacuum
Selecting “YES” activates the vacuum
parameter (firing under vacuum).
Vacuum release
(
⇒
=Selection)
During the heating up stage
⇒
“Release Vacuum Heat up”
During the hold time at final temperature
⇒
“Release Vacuum Hold time”
During the cooling stage
⇒
“Release Vacuum Cooling”
Vacuum end
Display shows temperature at which
the vacuum is released.
Edit done?
Saving of the program.
Program types - 3:
Special Program
This firing program is recommended for processing ceramic materials,
which require two holding times under vacuum and/or two different heat rates (specially for crystallization programs
for IPS e.max e.max
®
CAD)
1 Operation