Porcelain under 800 C
Temp difference 0C
Final temp
Lower
Porcelain over 800 C
Temp difference 0C
Final temp
Lower
Enter
Customize Calibration
450C
Esc
Users can
offset their calibration for ceramic programs
with final temperature above and/or below 800C all at
once without adjusting programs individually effecting
the actual calibration curve of the machine. This allows
more precise offset modification of temperatures with
the use of individually preferred temperature
measurement methodology.
From the "MAIN MENU" Select "SETUP OVEN" and press
the "ENTER" button.
From the "SETUP OVEN" menu, select "CUSTOMIZE
CALIBRATION" and press the "ENTER" button.
This will take you to the "CUSTOMIZE CALIBRATION"
screen where individual offsets can be entered for all
programs with final temperatures above and below
800C individually (High and low fusing).
To change the values:
On the "CUSTOMIZE CALIBRATION" screen, when
"CHANGE THESE VALUES?" is displayed, press the green
"Enter" button and the first "Temp Difference" will be
highlighted (indicating it is ready for adjustment).
Using the dialer or +/- buttons, indicate the number of
degrease you wish to change the temperature, then
press the green "Enter" button to proceed to the next
step.
Use the dialer or +/- buttons to indicate whether to
make the temperature "higher" or "lower" by the
number of degrease you just entered, then press the
green "Enter" button to proceed to the next stage.
repeat the previous two step
CUSTOMIZE CALIBRATION
-
+
Dialer
®
Made
in
Germany
Enter
Up
Down
V 200
MAIN MENU
450C
Run Programs
Edit Programs
Setup Oven
Run warm-up program
Start night mode
Section for selecting parameters:
Confirm / Cancel – key
Section for changing values
Rapid selection (circle dialer)
Step by step (yellow keys)
LCD color display
Current temperature
Initial oven setup
Enter
Setup Oven
450C
Change idle temp.
Change night temp.
Customize calibration
Vacuum pump operation
Set vacuum level
Diagnostic tests
Customize country
Adjust display
Audio beeps
Set preview mode
Esc
Change these values?