6
Seite
Seite
Seite
Seite
Seite
Page
0 Introduction
■
The VARIO 200 furnace series was exclusively
designed for the firing of dental ceramics, and is
intended only for those applications.
■
the user shall be liable for damages resulting
from any other use,
■
At temperatures above 1075°C/1967°F, the working
life of the heating muffle is reduced.
■
In case of defect of the furnace, the stated
warranty will apply provided that use conforms
to the specifications within this manual.
■
Repairs and maintenance may only be performed
by our authorized Customer Care Center.
■
Do not touch the screen with wet fingers.
■
Please unpack the oven with caution. It should
always be carried by two persons. Always lift
the device at the bottom, never at the furnace
chamber or table slide bar.
■
Never use hard or sharp objects to operate the
touch screen.
■
The oven must always have a firing brick on the
lift table.
■
During operation, never place your hand between
the lift table and the furnace chamber. There is a
risk of pinching, crushing and a burn hazard.
■
During operation never place your hand under
the lift table and do not put any objects under
the lift table.
■
Do not block the lift table during the opening
process.
■
The air vents must be kept free from obstruction
and clean at all times to allow proper air circulation.
If this is not done, there is a risk of overheating
the furnace.
■
Make sure that no liquids or other foreign objects
enter the furnace or the air vents, as this may
result in an electrical shock.
■
The lift of the furnace has an electrical lift drive
and has to be operated using the “Open” and
“Close” keys. Do not open or close the lift
manually.
0.5 Use within specifications