35 / 61
Identification: MD-AL-GI-00
Rev. 4.0 of 31.01.18 - Application: GID
Manual of 07/06/2019 Rev. 2.1 “User Manual for 1.1K-3K TL”
Figure 39 – Connecting an inverter with wi-fi
For a group of inverters, it is possible to connect the different wi-fi cards to a single terminal (router, wi-fi
modem and network extenders).
This procedure does not require the setting of a progressive Modbus address
on the various inverters.
Figure 40 – Connecting multiple inverters with Wi-Fi
To ensure proper transmission of the Wi-Fi signal, completely extract the Wi-Fi antenna by following the
procedure below.
1)
Loosen the cable gland of the Wi-Fi antenna.
2)
Pull out the Wi-Fi antenna for about 5 cm or until the cable gland prevents it from being pulled out
any further.
3)
Tighten the cable gland of the Wi-Fi antenna.
Figure 41 – Extracting the Wi-Fi antenna
For more information and instructions on how to configure the communication system, refer to the relevant
technical notes available at