42
Minipool
En - USE Of THE OTHEr cOnTrOLS
USE oF THE INTERNAL KEYBoARD
Setting the temperature
Use the UP/DOWN button to increase/decrease the temperature
value displayed: keeping it pressed
once
, the value
increases
,
keeping it pressed
twice
the value
decreases
. If the temperature
of the water is lower than the pre-set one, the heater will be auto-
matically enabled until the set temperature is reached.
The “heater” LED will light up in the “fixed” mode.
Start of the whirlpool
Pressing this button:
once
-> the
left-hand
nozzles of the minipool are activated.
twice
-> the
left-
and
right-hand
nozzles of the minipool are
activated at the same time.
3 times
-> the
right-hand
nozzles of the minipool are activated.
4 times
-> the function is deactivated.
Chromotherapy start
Pressing this button, chromotherapy is enabled: a sequence of
5
different colours
starts that are repeated cyclically.
Pressing the button a second time, the sequence is disabled and
the colour displayed at the time the button was pressed is held.
By pressing the button a third time, the chromotherapy function
will turn off.
CoNTRoL FUNCTIoNS FRoM INSIDE THE
MINIPooL
The temperature of the water cannot be adjusted
from inside the pool
but only using the keypad or re-
mote control.
“Left” button
By pressing this button, the
hydromassage
function of the nozzles on the left
of the
button is activated.
By pressing this button again, the hydromassage
function will turn off.
“Centre” button
It turns
chromotherapy on
: if a 5 colour sequence is in progress,
pressing it will deactivate the sequence and the colour displayed
at the time the button was pressed will be held.
By pressing the button a third time, the chromotherapy function
will turn off.
“Right” button
By pressing this button, the
hydromassage
function of the nozzles to the right
of the
button is activated. By pressing this button
again, the hydromassage function will turn off.
