ZUMEX Speed Pro User Manual Download

Page: 27 / 117

Plastic juicer filter (32)

Place on the inside of the juice container

(Fig. 2)

Peel bucket (33)

Place the peel buckets under the cover side outlets

(Fig. 2 or 3U depending on model)

Drip tray (34)

Place under the juice outlet

(Fig. 2 or 3U depending on model)

Self Service Juice container (40)

Assembly (Fig. 12).

Line up the tap detector tube

(45)

with the hole in the back of the container. Slide it until

the container fixing pins are fully inserted in the latch holes. Press firmly with your right

hand on the front of the container until you hear the click of the latch and then with your

left hand until you hear the click of the left latch. Ensure that it is correctly attached by

gently pulling on it.

Important!

The incorrect assembly of the container can lead to breaks in the seal and

small juice leaks. Always make sure that it is correctly fixed to the body of the machine

and that the container is in good condition.

Note:

To ensure the correct fit of the container, it is recommended to keep the fixing

latches clean of juice and/or dirt. Spray a detergent (Zumex Citric Active) in the container

fixing holes and the inner part as shown in picture 3.

(Fig. 12)

. Allow the detergent to work

for 1 minute. Repeatedly activate the latches and wipe away any remaining product with

a clean cloth.

Disassembly (Fig. 12).

To disassemble the container, press the left and right latches at the same time. Slide the

container out.

Self Service Sub-filter (41)

Place on the inside of the juice extraction container

(Fig. 3U)

Automatic PulpOut System (42+)

With this device pulp and seeds will be removed automatically during the juicing process.

Assembly (Fig. 20.1+ and 20.2+)

a) Place the rollers (42.1+) into the conveyor belt (42.2+).
b) First place the left hand roller into the metal socket on the frame. Then stretch the belt and

place the other roller into the right hand sockets.

(Fig. 20.1+)

c) Insert the ribbon cover (42.4+) by first of all guiding the right hand side pivots into the slots

on the frame (42.3+)

(Fig. 20.1+)

. Then rotate the cover until it rests completely on the frame

in a horizontal position and press down until it clips into place.
d) Press down lightly on the sides of the Side Cover (42.5+) and fit it into the holes on the left

hand side of the Frame

(Fig. 20.1+)

. Ensure that the pivots have been inserted completely,

and that the cover can rotate freely. Leave it in the vertical position.
e) Fit the PulpOut System (42+) into the machine

(Fig. 20.2+ and 20.3+)

. To do this, fit the

left roller onto the drive shaft on the left side of the machine. Make sure that the assembly

rests and is inserted into the pivots of the container.
f) Turn the Anti-Splash Cap (42.6+) is in a vertical position. It is possible to remove the PulpOut

System without removing the cover.

Note:

The anti-splash cap must be in a horizontal position to assemble the cover.

Disassembly (Fig. 20.3+)

To remove the PulpOut from the machine, pull it up and out. To disassemble the unit, reverse

the steps indicated for its assembly.

See the

Cleaning

section for the correct maintenance of the Automatic PulpOut System.

See how it is fitted in various models:
Speed S +plus (Fig. 3+).
Speed S +plus All-in-One (Fig. 4+).
Speed S +plus Tank All-in-One (Fig. 5+).