011302/01
3
4.- REPLACING THE PUSHER ASSEMBLY.
•
Extract the key from the blade shaft (Figs. 4a and 4b).
•
Dismantle the three runner covers in order to work safely.
•
Extract the top bolt from the bridge (M8x50 Allen) and the top pin (Fig. 4c).
•
Extract the pusher assembly (Fig. 4d).
4a
4b
4c
4d
5a
5b
5.- REPLACING THE BRIDGE.
•
Repeat Section 4 without needing to extract the pusher assembly.
•
Extract the bottom bolt from the bridge runner (M8x35Allen) (Fig.5a). This will
release the bridge.
•
On fitting the new bridge, fit the rod in the highest position and the cups in the
vertical position (Fig. 5b).
6.- REPLACING A RUNNER OR A CUP SPRING.
DISMANTLING
•
Carry out Step 4.
•
Dismantling the micro strip (Fig 6a).
•
Dismantle the top bar (Fig. 6b).
•
Dismantle the short micrometer (Fig. 6c)
6a
6b
6c
•
Dismantle the two cogs. (Fig. 6d).
