Introduction
9
1.2 Points to note when reading this operating manual
Text references
Chapter headings are numbered consecutively in the chapters, with the first figure corresponding
to the chapter number. Where reference is made to sections outside the current chapter, note the
first figure and turn to the corresponding chapter, which contains the cited section. See chapter 2.4
Cutter; overview, for example, leads to chapter 2 Product description, which contains section 4 Cutter
overview.
Block diagrams and simplified representation
Note that all representations are provided for general information and do not necessarily correspond to
the latest version of the machine.
Dimensional information
Dimensional information is listed in the SI/US units, depending on the installation site.
1.3 Publishing details
Designation
Operating instructions for S3 series cutters.
Layout, illustration, and print
Zünd Systemtechnik AG - Technical Communications Department
©
Copyright
Zünd Systemtechnik AG
Summary of Contents for S3 M-1200
