Auckland (Head Office)
20 Carr Rd, Three Kings
Auckland 1041
P:
09 624 1115
F:
09 624 1110
E:
sales@macdonaldindustries.co.nz
Wellington
P:
04 569 8033
F:
04 569 8066
www.macdonaldindustries.co.nz
Christchurch
P:
03 348 2356
F:
03 348 2376
1.0
INSTALLATION INSTRUCTIONS
1.1
1/2” BSP nipple should protrude 10mm from the finish wall on 200 centres. Supply pipes should
be secured to support the faucet.
1.2
Apply pipe sealant to 1/2” threads of supply pipe and screw supply arm assembly (item#5) onto
pipe. Position supplies to that the body connections end up at 200 centres on a horizontal plane.
1.3
Insert sink faucet body (item #4) to supply arms placing gasket (item#5A) between body and
supply arm.
1.4
Assemble spout to body using hardware.
1.5
Install wall brace by screwing the support rod into the threaded spout connection. Adjust the sup-
port rod to desired length and secure to finished wall using the two wood screws provided. Note:
Support for finished wall is recommended where wall brace mounts for maximum support.
1.6
Turn water supply on and operate faucet checking for leaks.
1.7
It may be necessary to shut water off and remove cartridges to clean supply lines. Cartridges can be
removed by first removing the handles. Colour indexes can be removed by inserting a pin into the
hole on the underside of the handle. After the handles have been removed unscrew the handle nuts
and pull out on the cartridge.
1.8
Replace cartridges in body and hand tighten handle nuts. Place handles on the cartridge stem and
locate them as desired. Tighten handle nuts.
1.9
Replace handle screws and colour index button.
1.10
If necessary, install aerator into spout and hand tighten. It may be necessary to unscrew and clean
aerator at start-up.
2.0 SERVICE INSTRUCTIONS
Your Zurn Aquaspec Faucet is furnished with integral supply stops to provide a complete shut off
of the water supply. Turn screw stops into body using 5/16” hex key wrench until water shuts off
completely. Turn stop no more than three (3) complete turns to activate water flow.
3.0 MAINTENANCE
3.1
Your Zurn Aquaspec Faucet has a rough polish nickel chrome plated finish. Clean with soap and
water or a mild cleaner. Do not use acids or toilet bowl cleaner as they will damage the finish.
3.2
Aquaspec Faucets contain ceramic disk cartridges which require no maintenance. To remove the
cartridge, shut off, loosen the handle nuts and pull up on the cartridge.
4.0 REPLACEMENT PARTS
Cold Water Cartridge Z-SF-RK3
Hot Water Cartridge Z-SF-RK4
Lever Handle Indicator Z-SF-RK1
MACDONALD INDUSTRIES LIMITED
INSTALLATION INSTRUCTIONS
07/14
