Transmission Range up to 130 Feet at 1080p
Two CAT5/6 cables
HDMI
35M35MIR
HDMI
HE2BIR-TX
HE2BIR-TX
HE2BIR-RX
IR Emitter
RF Remote
RF Base
IR Blaster
HE2BIR-TX
HE2BIR-RX
IR Blaster
IR Receiver
HDMI
HDMI
35M35MIR
HDMI
IR Diagram Using 3
rd
Party RF Controller
-‐
In this example you are using a RF remote that is communicating back to an RF
base
station that then outputs IR signal to equipment
and through the
HE2BIR/HE1BIR
transmitter
and receiver to control TV. The
IR blaster
will plug
into
the
HE2BIR/HE1BIR Rece
iver by the TV location
do not place the IR Blaster
directly
on the TVs IR Receiving window but a few inches away to avoid saturation. A 3
rd
party IR Emitter
can be used but please do not change
pin out to avoid damage. Not
all emitters are compatible.
Fr
om the IR output of your RF receiving base station use our Model: 35M35MIR
cable to plug from that output to the HE2BIR/HE1BIR transmitter IR Receiving
input.
Diagram Using Two HE2BIR’s Daisy Chained
-‐
In this example to increase distance
you can use two sets of
HE2BIR’s/HE1BIR’s as shown in the diagram. Note to pass the IR correctly on
the middle HE2BIR/HE1BIR transmitter and receiver you can simply point IR
Receiver and IR blaster to each other to extend IR signal. A plug and play way is
to use our Model: 35M35MIR cable. See diagram for details of connection.
IR NOTES CONTINUED
