LCT-1631A Manual V1.0
7
Installation
System Installer must adhere to Article 820-40 of the NEC that provides guidelines for proper
grounding and specifies that the cable ground shall be connected to the grounding system of the
building, as close to the point of cable entry as possible.
Unpacking and Inspection
Each unit is shipped factory tested. Ensure all items are removed from the container prior to discarding any
packing material.
Thoroughly inspect the unit for shipping damage with particular attention to connectors and controls. If there is
any sign of damage to the unit or damaged or loose connectors contact your distributor immediately. Do not put
the equipment into service if there is any indication of defect or damage.
Hardware Installations and Connections
It is highly recommended that quality cables and connectors be used for all video and audio source connections.
1.
The unit comes standard with HDMI, Component, and Composite video inputs. The modulator is
intelligently designed to detect the video input from the video source.
HDMI Connection:
Connect the HDMI cable from the video source into the HDMI input.
If using a
Component Video
Cable
, connect the Y (Green), Pb (Blue), and Pr (Red) video source
cable to the unit’s Component input port.
If using a
Composite Video
source, use RCA connectors to connect the
video source
(e.g., CATV,
DVD, VCR, Camera) to the unit’s CVBS port.
2.
Composite Audio input
: Connect A/V audio source (Left / Right Audio,
the red / white
AUDIO L and
AUDIO R
) to connect the
audio source
to the 3.5mm
Audio L/R
phone jack.
3.
Use a quality 75Ω coaxial cable with “F” connectors from the unit’s
RF Output.
4.
Connect the included power adapter to the unit’s
POWER
plug.
5.
Connect the power adapter to an appropriately rated AC power outlet.
DEVICE Programming and Setup:
Connecting to the GUI Interface:
Factory Default IP: 192.168.1.9
1.
Connect an Ethernet cable to the Utility Port of the LCT-1631A and to your PC/Laptop.
2.
Modify your PC/Laptop’s IP address to 192.168.1.100.
3.
Enter ‘192.168.1.9’ into your web browser.
4.
Make all required parameter changes.
5.
Save all changes.