ZX50
ZX50
ZX50
ZX50 Series
Series
Series
Series IP
IP
IP
IP PBX
PBX
PBX
PBX
V1.1 Editor:Yu
4
th
,June,2010
53
Step
Step
Step
Step 2
2
2
2::::
Set up the Provider Host in ZX50-B
Set up the service provider and calling rule in ZX50-B to make it register to ZX50-A. This
method is almost the same as above, EXCEPT you need to use the 210.11.25.127 as the
service provider instead of 192.168.1.21.
Step
Step
Step
Step 3
3
3
3::::
Set port forwarding in the router for ZX50-B
Use the same method as Step 1 do port forwarding in router-B for ZX50-B as above.
Setp4:
Setp4:
Setp4:
Setp4:
Link two ZX50 and make calls
Accordingly, set the 601 users in ZX50-A and 801 users in ZX50-B, and build the correct
dial rules as above, you can make calls between two the ZX50 IP PBX.
Noted:
Noted:
Noted:
Noted:
You can also apply a DDNS to get one fixed domain for both ZX50 IP PBX and
connect to each other rather than use the Port Forwarding in the router.
10.9
10.9
10.9
10.9 How
How
How
How to
to
to
to resolve
resolve
resolve
resolve problems
problems
problems
problems about
about
about
about hearing
hearing
hearing
hearing only
only
only
only on
on
on
on one
one
one
one side
side
side
side
If your IPPBX behind the Router, you should build a IP Address Map to resolve this
problem as follow:
Management---->Show Advanced Options ----> Global SIP Settings
--->NAT Support
