5
6
WARNING
• Use massager only as intended. Do not use attachments not
recommended by the manufacturer.
• Avoid stepping on the power cord to prevent damage or
electrocution.
• Properly unplug the unit after use. If necessary, turn off the
unit prior to unplug it during use.
• Turn off and unplug massager mid-use if you experience
severe pain or detect any malfunction or abnormal condition,
or there is a power outage or lightning storm.
• The appliance must only be supplied at safe extra low voltage
corresponding to the marking on the appliance.
• The appliance is only to be used with the power supply unit
provided with the appliance.
• Never operate this appliance if it has a damaged cord or plug,
if it is not working properly, if it has been dropped or damaged,
or dropped into water. Return the appliance to Zyllion for
examination and repair.
If a fault is found, stop use immediately and unplug the
power supply to avoid accidents or injuries. Please contact
the seller or manufacturer for repairs or replacements.
Discontinue use of this unit if:
• Any parts are exposed or appear damaged or defective.
• The electrical outlet is unusually loose.
• It is exposed to explosive or flammable fumes.
• It over heats, catches fire, or the smell of smoke or burning
electronics is present.
• Aerosol (spray) products are being used or where oxygen is
being administered.
• You experience any of the following:
• Numbness or weakness in the face, arm, or leg;
• Confusion or trouble speaking or understanding speech
• Vision problems in one or both eyes
• Difficulty walking or dizziness, loss of balance or problems
with coordination
• Severe headache
This massager is equipped with an overheat protection device &
programmed with a 20-minute Auto Shut-Off to ensure safety.
(UL approved power adaptor works with both 110-120V & 220-
240V electrical outlet)
If product becomes too warm, discontinue use and allow the unit
to cool before operating. If your massager overheats, its safety
device will automatically shut off the motor to ensure safety and
prevent damage. If overheating continues, unplug the power
cord and allow unit to cool off for 15-20 minutes before turning
it on again. Contact Customer Support if this continues.
CARE AND MAINTENANCE
• Make sure the unit is completely turned off prior to cleaning.
• Allow unit to cool before cleaning.
• Wipe device with a soft, lightly moistened cloth for easy
cleaning. Do not use abrasive cleaning agents such as
benzene, thinner or gasoline.
• Keep the unit away from heat sources, liquids, pets, or children.
• Store massager unit in a cool dry place and keep away from
flammable products, explosives, or chemical solutions.
• Do not wrap cord around massager unit when storing to avoid
cord damage.
