ZyWALL 10~100 Series Internet Security Gateway
Firewall Commands
10-1
Chapter 10
Firewall Commands
The following describes the firewall commands. See the
Command Interpreter
appendix for information on
the command structure.
Chart 10-1 Firewall Commands
FUNCTION
COMMAND
DESCRIPTION
F
F
i
i
r
r
e
e
w
w
a
a
l
l
l
l
S
S
e
e
t
t
-
-
U
U
p
p
config edit firewall active
<yes | no>
This command turns the firewall on or off.
config retrieve firewall
This command returns the previously saved
firewall settings.
config save firewall
This command saves the current firewall
settings.
D
D
i
i
s
s
p
p
l
l
a
a
y
y
config display firewall
This command shows the of all the firewall
settings including e-mail, attack, and the sets/
rules.
config display firewall set
<set #>
This command shows the current
configuration of a set; including timeout
values, name, default-permit, and etc.
If you don’t put use a number (#) after “set”,
information about all of the sets/rules appears.
config display firewall set
<set #> rule <rule #>
This command shows the current entries of a
rule in a firewall rule set.
Summary of Contents for 10 Series
