Chapter 8 Wireless
ZyWALL ATP Series User’s Guide
186
Each field is described in the following table.
Table 76 Configuration > Wireless > AP Management > Mgnt. AP List
LABEL
DESCRIPTION
Edit
Select an AP and click this button to edit its properties.
Remove
Select an AP and click this button to remove it from the list.
Note: If in the
Configuration > Wireless > Controller
screen you set the
Registration
Type
to
Always Accept
, then as soon as you remove an AP from this list it
reconnects.
Reboot
Select an AP and click this button to force it to restart.
DCS Now
Select one or multiple APs and click this button to use DCS (Dynamic Channel Selection) to
allow the AP to automatically find a less-used channel in an environment where there are
many APs and there may be interference.
Note: You should have enabled DCS in the applied AP radio profile before the
APs can use DCS.
Note: DCS is not supported on the radio which is working in repeater AP mode.
Log
Select an AP and click this button to go to the
Monitor > Log > View AP Log
screen to view
the selected AP’s current log messages.
Suppression On
Select an AP and click this button to enable the AP’s LED suppression mode. All the LEDs of
the AP will turn off after the AP is ready. This button is not available if the selected AP
doesn’t support suppression mode.
Suppression Off
Select an AP and click this button to disable the AP’s LED suppression mode. The AP LEDs
stay lit after the AP is ready. This button is not available if the selected AP doesn’t support
suppression mode.
#
This field is a sequential value, and it is not associated with any entry.
IP Address
This field displays the IP address of the AP.
MAC Address
This field displays the MAC address of the AP.
Model
This field displays the AP’s hardware model information. It displays
N/A
(not applicable) only
when the AP disconnects from the Zyxel Device and the information is unavailable as a
result.
R1 Mode / Profile /
ZyMesh Profile
This field displays the operating mode (
AP
,
MON
,
rootap
, or
repeater
), AP radio profile name
and ZyMesh profile name for Radio 1. It displays
-
for the ZyMesh profile for a radio not using
a ZyMesh profile.
R2 Mode / Profile /
ZyMesh Profile
This field displays the operating mode (
AP
,
MON
,
rootap
, or
repeater
), AP radio profile name
and ZyMesh profile name for Radio 2. It displays
-
for the ZyMesh profile for a radio not using
a ZyMesh profile.
Group
This field displays the name of the AP group to which the AP belongs.
The group becomes editable immediately upon clicking.
Mgnt. VLAN ID(AC)
This displays the Access Controller (the Zyxel Device) management VLAN ID setting for the
AP.
Mgnt. VLAN ID(AP)
This displays the runtime management VLAN ID setting on the AP.
VLAN Conflict
displays if
the AP’s management VLAN ID does not match the
Mgnt. VLAN ID(AC)
. This field displays
n/
a
if the Zyxel Device cannot get VLAN information from the AP.
Description
This field displays the AP’s description, which you can configure by selecting the AP’s entry
and clicking the
Edit
button.
