Chapter 8 Wireless
ZyWALL ATP Series User’s Guide
189
8.3.2 AP Policy
Use this screen to configure the AP controller’s IP address on the managed APs and determine the
action the managed APs take if the current AP controller fails. Click
Configuration > Wireless > AP
Management > AP Policy
to access this screen.
Figure 153
Configuration > Wireless > AP Management > AP Policy
Output Power
Set the output power of the AP.
Override Group SSID
Setting
Select this option to overwrite the AP SSID profile setting with the setting you configure here.
This section allows you to associate an SSID profile with the radio.
Edit
Select an SSID and click this button to reassign it. The selected SSID becomes editable
immediately upon clicking.
#
This is the index number of the SSID profile. You can associate up to eight SSID profiles with
an AP radio.
SSID Profile
Indicates which SSID profile is associated with this radio profile.
Override Group
VLAN Setting
Select this option to overwrite the AP VLAN setting with the setting you configure here.
Force Overwrite
VLAN Config
Select this to have the Zyxel Device change the AP’s management VLAN to match the
configuration in this screen.
Management VLAN
ID
Enter a VLAN ID for this AP.
As Native VLAN
Select this option to treat this VLAN ID as a VLAN created on the Zyxel Device and not one
assigned to it from outside the network.
Suppression On
Select this option to enable the AP’s LED suppression mode. All the LEDs of the AP will turn
off after the AP is ready.
If the check box is unchecked, it means the LEDs will stay lit after the AP is ready.
OK
Click
OK
to save your changes back to the Zyxel Device.
Cancel
Click
Cancel
to close the window with changes unsaved.
Table 77 Configuration > Wireless > AP Management > Mgnt. AP List > Edit AP List (continued)
LABEL
DESCRIPTION
