Chapter 10 Routing
ZyWALL ATP Series User’s Guide
305
Figure 207
Configuration > Network > Routing > Policy Route > Add/Edit (IPv6 Configuration)
The following table describes the labels in this screen.
Table 121 Configuration > Network > Routing > Policy Route > Add/Edit
LABEL
DESCRIPTION
Show Advanced
Settings / Hide
Advanced Settings
Click this button to display a greater or lesser number of configuration fields.
Create new Object
Use this to configure any new settings objects that you need to use in this screen.
Configuration
Enable
Select this to activate the policy.
Description
Enter a descriptive name of up to 31 printable ASCII characters for the policy.
Criteria
User
Select a user name or user group from which the packets are sent.
Incoming
Select where the packets are coming from; any, an interface, a tunnel, an SSL VPN, or the
Zyxel Device itself. For an interface, a tunnel, or an SSL VPN, you also need to select the
individual interface, VPN tunnel, or SSL VPN connection.
Source Address
Select a source IP address object, including geographic address and FQDN (group)
objects, from which the packets are sent.
Destination Address
Select a destination IP address object, including geographic address and FQDN (group)
objects, to which the traffic is being sent. If the next hop is a dynamic VPN tunnel and you
enable
Auto Destination Address
, the Zyxel Device uses the local network of the peer
router that initiated an incoming dynamic IPSec tunnel as the destination address of the
policy instead of your configuration here.
