Chapter 37 System
ZyWALL ATP Series User’s Guide
730
37.9.2 Service Control Rules
Click the
Add
or
Edit
icon in the
Service Control
table to add a service control rule.
Figure 497
Configuration > System > TELNET > Service Control Rule Add/Edit
The following table describes the labels in this screen.
37.10 FTP
You can upload and download the Zyxel Device’s firmware and configuration files using FTP. To use this
feature, your computer must have an FTP client.
37.10.1 Configuring FTP
To change your Zyxel Device’s FTP settings, click
Configuration > System > FTP
tab. The screen appears
as shown. Use this screen to specify from which zones FTP can be used to access the Zyxel Device. You
can also specify from which IP addresses the access can come.
Table 317 Configuration > System > TELNET > Service Control Rule Add/Edit
LABEL
DESCRIPTION
Create new
Object
Use this to configure any new settings objects that you need to use in this screen.
Address Object
Select
ALL
to allow or deny any computer to communicate with the Zyxel Device using Telnet.
Select a predefined address object to just allow or deny the computer with the IP address that
you specified to access the Zyxel Device using Telnet.
Zone
Select
ALL
to allow or prevent any Zyxel Device zones from being accessed using Telnet.
Select a predefined Zyxel Device zone on which a incoming service is allowed or denied.
Action
Select
Accept
to allow the user to access the Zyxel Device from the specified computers.
Select
Deny
to block the user’s access to the Zyxel Device from the specified computers.
OK
Click
OK
to save your customized settings and exit this screen.
Cancel
Click
Cancel
to exit this screen without saving
