Chapter 37 System
ZyWALL ATP Series User’s Guide
735
Figure 501
Configuration > System > SNMP
The following table describes the labels in this screen.
Table 321 Configuration > System > SNMP
LABEL
DESCRIPTION
Enable
Select the check box to allow or disallow the computer with the IP address that matches the IP
address(es) in the
Service Control
table to access the Zyxel Device using this service.
Server Port
You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
Trap
Community
Type the trap community, which is the password sent with each trap to the SNMP manager. The
default is public and allows all requests.
Destination
Type the IP address of the station to send your SNMP traps to.
Trap CAPWAP
Event
Select this option to have the Zyxel Device send a trap to the SNMP manager when a
managed AP is connected to or disconnected from the Zyxel Device.
SNMPv2c
Select the SNMP version for the Zyxel Device. The SNMP version on the Zyxel Device must match
the version on the SNMP manager.
Get
Community
Enter the
Get Community
, which is the password for the incoming Get and GetNext requests
from the management station. The default is public and allows all requests.
Set
Community
Enter the
Set community
, which is the password for incoming Set requests from the
management station. The default is private and allows all requests.
