Chapter 39 File Manager
ZyWALL ATP Series User’s Guide
767
Apply
Use this button to have the Zyxel Device use a specific configuration file.
Click a configuration file’s row to select it and click
Apply
to have the Zyxel Device use that
configuration file. The Zyxel Device does not have to restart in order to use a different
configuration file, although you will need to wait for a few minutes while the system
reconfigures.
The following screen gives you options for what the Zyxel Device is to do if it encounters an
error in the configuration file.
Figure 529
Maintenance > File Manager > Configuration File > Apply
Immediately stop applying the configuration file
- this is not recommended because it would
leave the rest of the configuration blank. If the interfaces were not configured before the first
error, the console port may be the only way to access the device.
Immediately stop applying the configuration file and roll back to the previous configuration
-
this gets the Zyxel Device started with a fully valid configuration file as quickly as possible.
Ignore errors and finish applying the configuration file
- this applies the valid parts of the
configuration file and generates error logs for all of the configuration file’s errors. This lets the
Zyxel Device apply most of your configuration and you can refer to the logs for what to fix.
Ignore errors and finish applying the configuration file and then roll back to the previous
configuration
- this applies the valid parts of the configuration file, generates error logs for all of
the configuration file’s errors, and starts the Zyxel Device with a fully valid configuration file.
Click
OK
to have the Zyxel Device start applying the configuration file or click
Cancel
to close
the screen
#
This column displays the number for each configuration file entry. This field is a sequential value,
and it is not associated with a specific address. The total number of configuration files that you
can save depends on the sizes of the configuration files and the available flash storage space.
File Name
This column displays the label that identifies a configuration file.
You cannot delete the following configuration files or change their file names.
The
system-default.conf
file contains the Zyxel Device’s default settings. Select this file and click
Apply
to reset all of the Zyxel Device settings to the factory defaults. This configuration file is
included when you upload a firmware package.
The
startup-config.conf
file is the configuration file that the Zyxel Device is currently using. If you
make and save changes during your management session, the changes are applied to this
configuration file. The Zyxel Device applies configuration changes made in the Web
Configurator to the configuration file when you click
Apply
or
OK
. It applies configuration
changes made via commands when you use the
write
command.
The
lastgood.conf
is the most recently used (valid) configuration file that was saved when the
device last restarted. If you upload and apply a configuration file with an error, you can apply
lastgood.conf to return to a valid configuration.
Table 340 Maintenance > File Manager > Configuration File (continued)
LABEL
DESCRIPTION
