Chapter 8 Wireless
ZyWALL ATP Series User’s Guide
190
Each field is described in the following table.
8.3.3 AP Group
Use this screen to configure AP groups, which define the radio, port, VLAN and load balancing settings
and apply the settings to all APs in the group. An AP can belong to one AP group at a time. Click
Configuration > Wireless > AP Management > AP Group
to access this screen.
Figure 154
Configuration > Wireless > AP Management > AP Group
Table 78 Configuration > Wireless > AP Management > AP Policy
LABEL
DESCRIPTION
Force Override AC IP
Config on AP
Select this to have the Zyxel Device change the AP controller’s IP address on the managed
AP(s) to match the configuration in this screen.
Override Type
Select
Auto
to have the managed AP(s) automatically send broadcast packets to find any
other available AP controllers.
Select
Manual
to replace the AP controller’s IP address configured on the managed AP(s)
with the one(s) you specified below.
Primary Controller
Specify the IP address of the primary AP controller if you set
Override Type
to
Manual
.
Secondary Controller Specify the IP address of the secondary AP controller if you set
Override Type
to
Manual
.
Fall back to Primary
Controller when
possible
Select this option to have the managed AP(s) change back to associate with the primary
AP controller as soon as the primary AP controller is available.
Fall Back Check
Interval
Set how often the managed AP(s) check whether the primary AP controller is available.
Firmware Updating
Updating Type
Specify how you want the Zyxel Device to upgrade AP firmware.
Select
CAPWAP
to have the Zyxel Device use CAPWAP (Control and Provisioning of Wireless
Access Points protocol) to automatically update firmware on the managed APs.
Select
FTP
to allow the managed APs to download the latest firmware from the Zyxel Device
using FTP.
Apply
Click
Apply
to save your changes back to the Zyxel Device.
Reset
Click
Reset
to return the screen to its last-saved settings.
