Chapter 13 Redirect Service
ZyWALL ATP Series User’s Guide
343
For SMTP traffic between
lan1
and
lan2
:
• a from LAN1 to LAN2 firewall rule to allow SMTP messages from
lan1
to
lan2
. Responses to this request
are allowed automatically.
• a SMTP redirect rule to forward SMTP traffic from
lan1
to SMTP server
A
.
For SMTP traffic between
lan2
and
wan1
:
• a from LAN2 to WAN firewall rule (default) to allow SMTP messages from
lan2
to
wan1
. Responses to
these requests are allowed automatically.
• a policy route to forward SMTP messages from SMTP server
A
to the Internet.
13.2 The Redirect Service Screen
To configure redirection of a HTTP or SMTP request, click
Configuration > Network > HTTP Redirect
. This
screen displays the summary of the redirect rules.
Note: You can configure up to one HTTP redirect rule and one SMTP redirect rule for each
(incoming) interface.
Figure 234
Configuration > Network > Redirect Service
The following table describes the labels in this screen.
Table 139 Configuration > Network > Redirect Service
LABEL
DESCRIPTION
Add
Click this to create a new entry.
Edit
Double-click an entry or select it and click
Edit
to open a screen where you can modify the
entry’s settings.
Remove
To remove an entry, select it and click
Remove
. The Zyxel Device confirms you want to
remove it before doing so.
Activate
To turn on an entry, select it and click
Activate
.
Inactivate
To turn off an entry, select it and click
Inactivate
.
Move
To change a rule’s position in the numbered list, select the rule and click
Move
to display a
field to type a number for where you want to put that rule and press [ENTER] to move the
rule to the number that you typed.
The ordering of your rules is important as they are applied in order of their numbering.
#
This field is a sequential value, and it is not associated with a specific entry.
