Chapter 24 Web Authentication
ZyWALL ATP Series User’s Guide
446
Creating/Editing an Authentication Policy
Open the
Configuration > Web Authentication > General
screen, then click the
Add
icon or select an
entry and click the
Edit
icon in the
Web Authentication Policy Summary
section to open the
Auth. Policy
Add/Edit
screen. Use this screen to configure an authentication policy.
Figure 307
Configuration > Web Authentication > General > Add Authentication Policy
The following table gives an overview of the objects you can configure.
Table 182 Configuration > Web Authentication > General > Add Authentication Policy
LABEL
DESCRIPTION
Create new
Object
Use to configure any new settings objects that you need to use in this screen. Select Address or
Schedule.
Enable Policy
Select this check box to activate the authentication policy. This field is available for user-
configured policies.
Description
Enter a descriptive name of up to 60 printable ASCII characters for the policy. Spaces are
allowed. This field is available for user-configured policies.
User
Authentication
Policy
Use this section of the screen to determine which traffic requires (or does not require) the
senders to be authenticated in order to be routed.
Incoming
Interface
Select the interface on which packets for this policy are received.
Source Address
Select a source address or address group, including geographic address and FQDN (group)
objects, for whom this policy applies. Select
any
if the policy is effective for every source. This is
any
and not configurable for the default policy.
Destination
Address
Select a destination address or address group, including geographic address and FQDN
(group) objects, for whom this policy applies. Select
any
if the policy is effective for every
destination. This is
any
and not configurable for the default policy.
Schedule
Select a schedule that defines when the policy applies. Otherwise, select
none
and the rule is
always effective. This is
none
and not configurable for the default policy.
