Chapter 25 Security Policy
ZyWALL ATP Series User’s Guide
481
25.4.2 The Security Policy Control Add/Edit Screen
In the
Security Policy
Control
screen, click the
Edit
or
Add
icon to display the
Security Policy Edit or Add
screen.
Figure 329
Configuration > Security Policy > Policy Control > Add
The following table describes the labels in this screen.
Table 191 Configuration > Security Policy > Policy Control > Add
LABEL
DESCRIPTION
Create new
Object
Use to configure any new settings objects that you need to use in this screen.
Enable
Select this check box to activate the Security policy.
Name
Type a name to identify the policy
Description
Enter a descriptive name of up to 60 printable ASCII characters for the Policy. Spaces are
allowed.
From
To
For through-Zyxel Device policies, select the direction of travel of packets to which the policy
applies.
any
means all interfaces.
Device
means packets destined for the Zyxel Device itself.
Source
Select an IPv4 / IPv6 address or address group object, including geographic address and FQDN
(group) objects, to apply the policy to traffic coming from it. Select
any
to apply the policy to all
traffic coming from IPv4 / IPv6 addresses.
Destination
Select an IPv4 / IPv6 address or address group, including geographic address and FQDN (group)
objects, to apply the policy to traffic going to it. Select
any
to apply the policy to all traffic going
to IPv4 / IPv6 addresses.
Service
Select a service or service group from the drop-down list box.
