Chapter 4 Quick Setup Wizards
ZyWALL ATP Series User’s Guide
75
Figure 56
WAN and ISP Connection Settings: (L2TP)
•
ISP Parameter
: This section appears if the interface uses a PPPoE or PPTP Internet connection.
•
Encapsulation
: This displays the type of Internet connection you are configuring.
•
Service Name
: Type the PPPoE service name if you were given one by your ISP.
•
Authentication Type:
Use the drop-down list box to select an authentication protocol for outgoing
calls. Options are:
•
CHAP/PAP
- Your Zyxel Device accepts either CHAP or PAP when requested by this remote node.
•
CHAP
- Your Zyxel Device accepts CHAP only.
•
PAP
- Your Zyxel Device accepts PAP only.
•
MSCHAP
- Your Zyxel Device accepts MSCHAP only.
•
MSCHAP-V2
- Your Zyxel Device accepts MSCHAP-V2 only.
•
User Name
: Type the user name given to you by your ISP. You can use alphanumeric and -_
@$./
characters, and it can be up to 31 characters long.
•
Password:
Type the password associated with the user name above. Use up to 64 ASCII characters
except the [] and ?. This field can be blank.
•
Retype
to Confirm
: Type your password again for confirmation.
•
Nailed-Up
: Select
Nailed-Up
if you do not want the connection to time out.
•
Idle Timeout
: Type the time in seconds that elapses before the router automatically disconnects from
the PPPoE server. 0 means no timeout.
•
PPTP Configuration
: This section only appears if the interface uses a PPTP Internet connection.
•
Base Interface
: This displays the identity of the Ethernet interface you configure to connect with a
modem or router.
•
Base IP Address
: Type the (static) IP address assigned to you by your ISP.
