Chapter 19 Parental Control
EMG6726/8726-B10A User’s Guide
197
The following table describes the fields in this screen.
Click
Security
>
Parental Control
>
Add New PCP
>
Add New Service
to open the following screen.
Figure 130
Parental Control Rule: Add/Edit Rule > Add New Service
Table 81 Parental Control Rule: Add/Edit
LABEL
DESCRIPTION
General
Active
Select to enable or disable this parental control rule.
Parental Control
Profile Name
Enter a descriptive name for the rule.
Home Network
User
Select the LAN user that you want to apply this rule to from the drop-down list box. If you select
Custom
, enter the LAN user’s MAC address. If you select
All
, the rule applies to all LAN users.
Rule List
In
Home Network User
, select
Custom
, enter the LAN user’s MAC address, then click the
Add
icon to enter a computer MAC address for this PCP. Up to five are allowed. Click the
Delete
icon
to remove one.
Internet Access Schedule
Day
Select check boxes for the days that you want the EMG to perform parental control.
Time
Drag the time bar to define the time that the LAN user is allowed access (
Authorized access
) or
denied access (
No access
). Click the
Add
icon above the time bar to add a new time bar. Up
to three are allowed.
Network Service
Network Service
Setting
If you select
Block
, the EMG blocks access to all the network services listed below.
If you select
Allow
, the EMG blocks access to all the network services except ones listed below.
Add New
Service
Click this to show a screen in which you can add a new service rule. You can configure the
Service Name
,
Protocol
, and
Port
of the new rule.
#
This shows the index number of the rule.
Service Name
This shows the name of the rule.
Protocol:Port
This shows the protocol and the port of the rule.
Modify
Click the
Edit
icon to go to the screen where you can edit the rule.
Click the
Delete
icon to delete an existing rule.
OK
Click
OK
to save your changes.
Cancel
Click
Cancel
to exit this screen without saving.