Chapter 1 Introducing the EMG
EMG6726/8726-B10A User’s Guide
24
Figure 7
EMG67256-B10A’s Rear Panel
Figure 8
EMG8726-B10A’s Rear Panel
The following table describes the items on the rear panel.
1.4.5 The RESET Button
If you forget your password or cannot access the Web Configurator, you will need to use the
RESET
button at the back of the device to reload the factory-default configuration file. This means that you will
lose all configurations that you had previously and the password will be reset to the factory default (see
the device label).
1
Make sure the
POWER
LED is on (not blinking).
2
To set the device back to the factory default settings, press the
RESET
button for more than ten seconds
or until the
POWER
LED begins to blink and then release it. When the
POWER
LED begins to blink, the
defaults have been restored and the device restarts.
Table 4 Rear Panel Ports
LABEL
DESCRIPTION
ETHERNET1 ~
ETHERNET4
Connect computers or other Ethernet devices to Ethernet ports for Internet
access.
WAN
Connect an Ethernet cable to the Ethernet WAN port for Internet access.
PHONE1
~PHONE2
Connect analog phones to the phone ports to make phone calls.
USB
The USB port is reserved for future development.
Reset
Press the button to return the EMG to the factory defaults.
Power
Connect the power cable and press the power button to start the EMG.
