Chapter 6 Broadband
EMG6726/8726-B10A User’s Guide
73
6.2.1.2 Bridge Mode
Click the
Add new WAN Interface
in the
Network Setting > Broadband
screen or the
Edit
icon next to the
connection you want to configure. Select
Bridge
as the encapsulation mode. The screen varies
depending on the interface type you select.
If you select
Ethernet
as the interface type, the following screen appears.
Figure 27
Network Setting > Broadband > Add New WAN Interface/Edit (Ethernet-Bridge Mode)
The following table describes the fields in this screen.
Primary DNS
Server
Enter the first IPv6 DNS server address assigned by the ISP.
Secondary DNS
Server
Enter the second IPv6 DNS server address assigned by the ISP.
OK
Click
OK
to save your changes back to the EMG.
Cancel
Click
Cancel
to exit this screen without saving.
Table 12 Network Setting > Broadband > Add New WAN Interface/Edit (Routing Mode) (continued)
LABEL
DESCRIPTION
Table 13 Network Setting > Broadband > Add New WAN Interface/Edit (Ethernet-Bridge)
LABEL
DESCRIPTION
General
Active
Select
Enable
to enable this WAN interface.
Name
Enter a service name of the connection.
Type
Select
Ethernet
as the interface that you want to configure.
Mode
Select
Bridge
when your ISP provides you more than one IP address and you want the connected
computers to get individual IP address from ISP’s DHCP server directly. If you select
Bridge
, you
cannot use routing functions, such as QoS, Firewall, DHCP server and NAT on traffic from the
selected LAN port(s).
VLAN