Chapter 9 Routing
EMG6726/8726-B10A User’s Guide
128
Figure 75
Routing: Add/Edit
The following table describes the labels in this screen.
9.3 The DNS Route Screen
Use this screen to view and configure DNS routes on the EMG. Click
Network Setting > Routing > DNS
Route
to open the
following
screen.
Table 33 Routing: Add/Edit
LABEL
DESCRIPTION
Active
This field allows you to activate/deactivate this static route.
Select
Enable
to activate the static route. Select
Disable
to deactivate this static route without
having to delete the entry.
Route Name
Enter a descriptive name for the static route.
IP Type
Select whether your IP type is
IPv4
or
IPv6
.
Destination IP
Address
Enter the IPv4 or IPv6 network address of the final destination.
IP Subnet Mask
If you are using IPv4 and need to specify a route to a single host, use a subnet mask of
255.255.255.255 in the subnet mask field to force the network number to be identical to the host
ID. Enter the IP subnet mask here.
Use Gateway IP
Address
The gateway is a router or switch on the same network segment as the device's LAN or WAN
port. The gateway helps forward packets to their destinations.
If you want to use the gateway IP address, select
Enable
.
Gateway IP
Address
Enter the IP address of the gateway.
Use Interface
Select the WAN interface you want to use for this static route.
OK
Click
OK
to save your changes.
Cancel
Click
Cancel
to exit this screen without saving.
