Chapter 10 Quality of Service (QoS)
EMG6726/8726-B10A User’s Guide
145
10.6.1 Add/Edit a QoS Shaper
Click
Add
New Shaper
in the
Shaper Setup
screen or the
Edit
icon next to a shaper to show the following
screen.
Figure 87
Shaper Setup: Add/Edit
The following table describes the labels in this screen.
10.7 The QoS Policer Setup Screen
Use this screen to view QoS policers that allow you to limit the transmission rate of incoming traffic and
apply actions, such as drop, pass, or modify the DSCP value for matched traffic. Click
Network Setting >
QoS >
Policer Setup
. The screen appears as shown.
Figure 88
Network Setting > QoS > Policer Setup
Table 45 Shaper Setup: Add/Edit
LABEL
DESCRIPTION
Active
Select to enable or disable this shaper.
Interface
Select the EMG's interface through which traffic in this shaper applies
Rate Limit
Enter the average rate limit of traffic bursts for this shaper.
OK
Click
OK
to save your changes.
Cancel
Click
Cancel
to exit this screen without saving.
