Chapter 13 Bandwidth Control
MES-2110 User’s Guide
112
The following table describes the related labels in this screen.
Table 38
Configuration > Bandwidth Control
LABEL
DESCRIPTION
Bandwidth Control Configuration
Port Number Use this to select a port number.
Mode
This shows the Ingress (incoming) or Egress (outgoing) mode.
Rate Level
Select a rate range from the list. Options are: 64K~960K (64+), 1M~100M
(1M+), 110M~1000M (10M+).
Rate Limit
Specify the maximum bandwidth allowed for the traffic flow on a port. The
unit changes depending on how you configure in the Rate Level field. The
value you enter in this field must be within the rate level range.
Active
Use this to enable or disable bandwidth control.
Undo
Click this to restore your last saved settings.
Apply
Click Apply to save your changes to the MES-2110’s run-time memory.
The MES-2110 loses these changes if it is turned off or loses power, so use
the Save Settings link in the navigation panel to save your changes to the
non-volatile memory when you are done configuring.
Bandwidth Control Status
Port
This is the port number.
Ingress Limit This is the ingress rate limit on the port.
Active
This shows whether bandwidth control for ingress traffic is enabled or
disabled on the port.
Egress Limit
This is the egress rate limit on the port.
Active
This shows whether bandwidth control for egress traffic is enabled or
disabled on the port.
Summary of Contents for ES-100
