Chapter 6 LAN Setup
P-793H User’s Guide
98
6.3.1 Configuring Advanced LAN Setup
Use this screen to edit your ZyXEL Device's advanced LAN settings. Click the
Advanced
Setup
button in the
LAN IP
screen. The screen appears as shown.
Figure 39
LAN > IP > Advanced Setup
The following table describes the labels in this screen.
Table 25
LAN > IP > Advanced Setup
LABEL
DESCRIPTION
RIP & Multicast
Setup
RIP Direction
RIP (Routing Information Protocol, RFC 1058 and RFC 1389) allows a router to
exchange routing information with other routers. The
RIP Direction
field controls
the sending and receiving of RIP packets. Select the RIP direction from
Both
/
In
Only
/
Out Only
/
None
. When set to
Both
or
Out Only
, the ZyXEL Device will
broadcast its routing table periodically. When set to
Both
or
In Only
, it will
incorporate the RIP information that it receives; when set to
None
, it will not send
any RIP packets and will ignore any RIP packets received.
RIP Version
This field is enabled if
RIP Direction
is not
None
. The
RIP Version
field controls
the format and the broadcasting method of the RIP packets that the ZyXEL Device
sends (it recognizes both formats when receiving).
RIP-1
is universally supported
but RIP-2 carries more information. RIP-1 is probably adequate for most networks,
unless you have an unusual network topology. Both
RIP-2B
and
RIP-2M
sends the
routing data in RIP-2 format; the difference being that
RIP-2B
uses subnet
broadcasting while
RIP-2M
uses multicasting. Multicasting can reduce the load on
non-router machines since they generally do not listen to the RIP multicast address
and so will not receive the RIP packets. However, if one router uses multicasting,
then all routers on your network must use multicasting, also.
Multicast
IGMP (Internet Group Multicast Protocol) is a network-layer protocol used to
establish membership in a multicast group. The ZyXEL Device supports both IGMP
version 1 (
IGMP-v1
) and
IGMP-v2
. Select
None
to disable it.
Windows
Networking
(NetBIOS over
TCP/IP)
NetBIOS (Network Basic Input/Output System) are TCP or UDP packets that
enable a computer to connect to and communicate with a LAN. For some dial-up
services such as PPPoE or PPTP, NetBIOS packets cause unwanted calls.
However it may sometimes be necessary to allow NetBIOS packets to pass
through to the WAN in order to find a computer on the WAN.
Allow between
LAN and WAN
Select this check box to forward NetBIOS packets from the LAN to the WAN and
from the WAN to the LAN. If your firewall is enabled with the default policy set to
block WAN to LAN traffic, you also need to enable the default WAN to LAN firewall
rule that forwards NetBIOS traffic.
Clear this check box to block all NetBIOS packets going from the LAN to the WAN
and from the WAN to the LAN.
Back
Click
Back
to return to the previous screen.
Summary of Contents for G.SHDSL.bis 4-port Security Gateway P-793H
