Chapter 34 Access Control
GS1350 Series User’s Guide
276
34.5 Service Access Control
Service Access Control allows you to decide what services you may use to access the Switch. You may
also change the default service port and configure “trusted computers” for each service in the
Remote
Management
screen (discussed later). Click
Access Control
to go back to the main
Access Control
screen.
Figure 205
Management > Access Control > Service Access Control
The following table describes the fields in this screen.
Privilege
Type the privilege level for this user. At the time of writing, users may have a privilege level of 0,
3, 13, or 14 representing different configuration rights as shown below.
• 0 – Display basic system information.
• 3 – Display configuration or status.
• 13 – Configure features except for login accounts, SNMP user accounts, the
authentication method sequence and authorization settings, multiple logins, administrator
and enable passwords, and configuration information display.
• 14 – Configure login accounts, SNMP user accounts, the authentication method
sequence and authorization settings, multiple logins, and administrator and enable
passwords, and display configuration information.
Users can run command lines if the session’s privilege level is greater than or equal to the
command’s privilege level. The session privilege initially comes from the privilege of the login
account. For example, if the user has a privilege of 5, he/she can run commands that requires
privilege level of 5 or less but not more.
Apply
Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the
Save
link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel
Click
Cancel
to begin configuring this screen afresh.
Table 136 Management > Access Control > Logins (continued)
LABEL
DESCRIPTION
Table 137 Management > Access Control > Service Access Control
LABEL
DESCRIPTION
Services
Services you may use to access the Switch are listed here.
Active
Select this option for the corresponding services that you want to allow to access the Switch.
Service Port
For Telnet, SSH, FTP, HTTP or HTTPS services, you may change the default service port by typing
the new port number in the
Service Port
field. If you change the default port number then you
will have to let people (who wish to use the service) know the new port number for that
service.
