Chapter 4 Web Configurator
GS1350 Series User’s Guide
45
6
Select the Web Configurator in
Standard Mode
that has a complete set of configuration for network
installation. Or select the Web Configurator in
Surveillance Mode
that has a set of menus specifically
designed for users who are mostly using the Switch for configuring and managing PoE devices like IP
cameras (
).
7
The
Setup
Wizard
screen will appear after selecting the mode. You can use the
Setup Wizard
screen to
configure the Switch’s IP, login password, SNMP community, link aggregation, and so on. See
Setup Wizard
screen. When you finish configuring the settings,
you can click the
Apply
& Save
button to make the settings take effect, and save your configuration
into the Switch’s non-volatile memory at once. Check the screens to see if the settings are applied.
Note: Once you click the
Apply & Save
button, the settings configured in the
Setup
Wizard
screen will overwrite the existing settings.
Otherwise, click the
Exit
button. You can select the
Ignore this wizard next time
check box and click
Apply
& Save
if you do not want the
Setup Wizard
screen to appear the next time you log in. If you want
to open the
Setup Wizard
screen later, click the
Wizard
icon in the upper right hand corner of the Web
Configurator.
Figure 29
Web Configurator: Wizard
8
If you did not change the default administrator password and/or SNMP community values, a warning
screen displays each time you log into the Web Configurator. Click
Password / SNMP
to open a screen
where you can change the administrator and SNMP passwords simultaneously. Otherwise, click
Ignore
to close it.
