Chapter 3 Hardware Panels
GS1350 Series User’s Guide
36
Note: Do NOT pull the transceiver out by force. You could damage it. If the transceiver will not
slide out, grasp the tabs on both sides of the transceiver with a slight up or down motion
and carefully slide it out of the slot. If unsuccessful, contact Zyxel Support to prevent
damage to your Switch and transceiver.
5
Insert the dust plug into the ports on the transceiver and the cables.
Figure 17
Removing the Fiber Cables
Figure 18
Opening the Transceiver’s Latch Example
Figure 19
Transceiver Removal Example
3.1.4 Dual Personality Interfaces
A combo port is for uplink connections. It consists of a Gigabit Ethernet port for Ethernet connection,
and a SFP transceiver slot for fiber connection. The fiber connection takes priority if the corresponding
Gigabit port is also connected.
• 100 Mbps/1 Gbps – Connect these ports to high-bandwidth backbone network Ethernet switches.
• Transceiver Slots – Use SFP transceivers in these slots for connections to backbone Ethernet switches.
Figure 20
Combo Port Example: Gigabit Port and SFP Transceiver Slot
3.2 Rear Panel
The following figures show the rear panels of the Switch.
