3
rev.1.0a
Green Blinking
The port is transmitting/receiving packets, and the
connection speed is 1000Mbps.
Amber
On
The port is enabled and established a link to connected
device, and the connection speed is 100Mbps.
Amber Blinking
The port is transmitting/receiving packets, and the
connection speed is 100Mbps.
--
Off
The port has no active network cable connected, or it is
not established a link to connected device. Otherwise, the
port may have been disabled through the switch user
interface.
Reset Button
By pressing the Reset Button for certain period of time, users can perform
the following tasks.
•
Reset the Switch
to reboot and get the switch back to the previous configuration
settings saved.
•
Restore the Switch to Factory Defaults
to restore the original factory default settings back to the switch.
Note
:
According to the table below, users can easily judge which task is being
performed by reading the LED behaviors while pressing the Reset button.
Once the LED behaviors are correctly displayed, users may just
release the button.
Table 3: Mode/Reset Button Descriptions
Task to be
Performed
Time Period of
Pressing Button
SYS LED
Behavior
Port Status LED
Behavior
Reset the Switch
2 ~ 7 seconds
Blinking
Green
ALL LEDs Light OFF
Restore to Defaults 7 ~ 12 seconds
Blinking
Green
ALL LEDs Stay ON
