Chapter 8 Basic Setting
GS1915 Series User’s Guide
95
8.5.5 Network Proxy Configuration
The proxy server of an organization may prohibit communication between the Switch and NCC (Nebula
Control Center)(
screen to enable communication between the
Switch and NCC through the proxy server.
Figure 69
Network Proxy Configuration Application
As of this writing, this setting only allows communication between the Switch and the NCC.
Figure 70
Basic Setting > IP Setup > IP Configuration > Network Proxy Configuration
The following table describes the labels in this
screen.
Table 32 Basic Setting > IP Setup > IP Configuration > Network Proxy Configuration
LABEL
DESCRIPTION
Active
Select this option to enable communication between the Switch and NCC through a proxy
server.
Server
Enter the IP address (dotted decimal notation) or host name of the proxy server. When entering
the host name, up to 128 alphanumeric characters are allowed for the
Server
except [ ? ], [ | ],
[ ' ], or [ " ].
Port
Enter the port number of the proxy server (1 – 65535).
Authentication
Select this option to enable proxy server authentication using a
Username
and
Password
.
Username
Enter a login user name from the proxy server administrator. Up to 32 alphanumeric characters
are allowed for the
Username
except [ ? ], [ | ], [ ' ], or [ " ].
Password
Enter a login password from the proxy server administrator. Up to 32 alphanumeric characters
are allowed for the
Password
except [ ? ], [ | ], [ ' ], or [ " ].
Apply
Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the
Save
link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel
Click
Cancel
to reset the fields to your previous configuration.
