Chapter 33 Link Layer Discovery Protocol (LLDP)
GS2210 Series User’s Guide
299
Figure 208
Advanced Applicat ion > LLDP > LLDP Configurat ion
The follow ing t able descr ibes t he labels in t his scr een.
Table 142
Advanced Applicat ion > LLDP > LLDP Configurat ion
LABEL
DESCRIPTION
Act ive
Select t o enable LLDP on t he Sw it ch. I t is enabled by default .
Transm it I nt er val
Ent er how m any seconds t he Sw it ch wait s befor e sending LLDP packet s.
Transm it Hold
Ent er t he t im e- t o- live ( TTL) m ult iplier of LLDP fram es. The device infor m at ion on t he
neighboring dev ices ages out and is discar ded w hen it s corr esponding TTL expir es. The
TTL value is t o m ult iply t he TTL m ult iplier by t he LLDP packet s t ransm it t ing int er val.
Transm it Delay
Ent er t he delay ( in seconds) bet w een successive LLDPDU t ransm issions init iat ed by
value or st at us changes in t he Sw it ch MI B.
Reinit ialize Delay
Ent er t he num ber of seconds for LLDP t o wait befor e init ializing on a por t .
Apply
Click Apply t o save your changes t o t he Sw it ch’s run- t im e m em ory. The Sw it ch loses
t hese changes if it is t ur ned off or loses pow er, so use t he Sa v e link on t he t op
navigat ion panel t o save your changes t o t he non- volat ile m em ory w hen you ar e done
configur ing.
Cancel
Click Ca n ce l t o begin configur ing t his scr een afr esh.
Port
This display s t he Sw it ch’s por t num ber. * m eans all por t s.
